Just plug your z-endstop wire on our board and configure the firmware, and let the printer do the rest...
- Detects all build plate types (including glass)
- 12/24v printer compatible
- 2 pins or 3 pin Z-end stop wiring configuration(100% compatible with creality printers and almost the printers with marlin firmware)
- Dc power jack 5.5x2.1mm center positive compatible (can also be connected to the printer power supply, no power adaptor needed).
- Led power on
- Led sensor status
- Will work with almost all ATMEL or ATMEGA based 3d printers. Only works on printers with Marlin firmware.
Each kit will contain
1 – AutoLev sensor
1 – AutoLev board
1 – power adapter (your chosen type, not included on the kit)
2 – 10mm M4 head machine screws
2 – 8mm M3 head machine screws
2 – M4 T-nuts
10 – Zip ties
1 - Installation Guide (will be emailed to you after you purchase)
1 - Live time tech support.
Installing the sensor
Installing the firmware
About the sensor
Its a 18mm capacitive sensor, compatible with all build surfaces, with a faster sample rate and accurate sensability, give a high precision for a perfect bed leveling.
8150-039 São Bras de Alportel